Initial Diagnostic Audit - Unit F7: Trigonometry
Section F7.1 - Pythagoras' Theorem

For each of the diagrams below, calculate the value of x.

1.
x = cm  
2.
x = cm  
3.
x = cm Give your answer correct to 2 d.p.  
4.
x = cm Give your answer correct to 2 d.p.  
5. The diagram below shows the cross-section of a shed.

Calculate the length, AB, of the roof, giving your answer in metres, correct to two decimal places.
AB = m
Section F7.2 - Further Work with Pythagoras' Theorem

For each of the diagrams below, calculate the length of the side marked x.
Give your answers correct to 1 d.p.

6.
  x = cm
7.
  x = cm
8.
  x = cm
9. Which of these triangles is a right angled triangle?


10. A toy is made from a cone attached to a wedge, as shown in the cross section diagram below.


What is the height of the cone? Give your answer to the nearest mm. Height = cm

Section F7.3 - Sine, Cosine and Tangent
11. In the triangle below, which is the adjacent side for the angle θ?.
12. For the triangle below, give the value of sinθ, cosθ and tanθ as a fraction.
(a)   sinθ = 
  
  
(b)   cosθ = 
  
(c)   tanθ = 
  
13. Use your calculator to find the angle θ to one decimal place, if sinθ = 0.65
θ = °
Section F7.4 - Finding Lengths in Right Angled Triangles
14. What are the values of x and y in the right angled triangle below?
Give your answers to 1 d.p.

(a)  x = cm

(b)  y = cm

15. What is the length of AB in the right angled triangle below?
Give your answer to 1 d.p.

AB = cm

16. What is the value of x in the triangles below?
Give your answers to 1 d.p.

x = m

17. What is the value of x in the triangles below?
Give your answers to 1 d.p.

x = cm

Section F7.5 - Finding Angles in Right Angled Triangles

Find the angle θ , to the nearest whole number, for each of these right angled triangles.

18.
  θ = °
19.
  θ = °
20.
  θ = °
21. The diagram below shows a simple bridge, supported by four steel cables.

Calculate the angles α and β shown, giving your answers to 1 d.p.

(a)  α = °

(b)  β = °


Marking your audit and producing your report

Once you are happy you have completed the audit, click the button below to mark your audit.
You will not be able to mark the audit again once you have clicked this button.
Mark your answers.

Now you can click the button below to produce your report. This button can be used more than once.
Produce your report.


< Back to Unit Menu
Produced by Russell Geach for CIMT - August 2014